Hydrostatic testing Study guides, Class notes & Summaries

NFPA 10 Exam 99 Questions with Verified Answers (SI) - CORRECT ANSWER International System of Units 1 in=. mm - CORRECT ANSWER 25.4 Approved - CORRECT ANSWER Acceptable to the authority having jurisdiction. (AHJ) - CORRECT ANSWER Authority Having Jurisdiction O rganization, office or individual responsible for enforcing requirements of a code or standard, or for approving equipment, materials, an installation or procedure. Shall - CORRECT ANSWER Indicates a mandatory requirement....

NFPA 10 Exam 71 Questions with Verified Answers When should wheeled fire extinguishers be considered? - CORRECT ANSWER • High hazard areas are present. • Limited available personnel are present. Requiring: High agent flow rate, Increased agent stream range, increased agent capacity NON-DOT low pressure fire extinguisher cylinders that pass a hydrostatic test shall have the following recorded on a label: - CORRECT ANSWER • Month and year test was performed (perforated) • Test pre...

On low pressure chillers, moisture typically enters the refrigerant system through air leaks from areas with gaskets or fittings The maximum test pressure for leak testing a low pressure centrifugal is: 10 psig Leak test and repair the chiller to reduce refrigerant loss from a pruge unit on CFC-11 chiller ... A hydrostatic tube test kit is used to: determine if a tube leaks Commercial and industrial process refrigeration systems must be repaired when the leak rate...

What is a general requirement of the location of the installation of a boiler? - ANSWERSAdequate clearance from combustile construction What temperature must the materials remain under during combustion? - ANSWERS170 degrees What is a requirement for the access of the boiler? - ANSWERSAccess for operation and maintenance must not be hazardous What is required upon installation to operate a boiler? - ANSWERSInspection and test resulting in equipment use permit from commissioner How of...

Dive Master NAUI Exam Latest Update Actual Questions and Answers with complete solution What pressure will a scuba cylinder with a rated working pressure of 3000 psig (207 bar), be exposed to during a hydrostatic test? 5000 psig (345 bar) Which principle represents one basis for the hydrostatic testing of scuba cylinders? Permanent expansion If a visual cylinder inspection reveals corrosion inside a scuba cylinder, it may require cleaning by a process called: Tumbling Which of the follo...

Chapter 8. Hydrostatic Testing

T/F A three dimensional fire often involves static flammable liquid. False. 3D fires involve flammable liquid in motion as well as both horizontal and vertical surfaces. Class A fire extinguisher are ok for ___________, ____________, ______________, and _______________. They offer the coating effects of dry chemicals. wood, paper, some plastics, and textiles When should dry chemical stored pressure fire extinguishers be removed and replaced? at their next 6 year maintenance or h...

Chapter 8. Hydrostatic Testing

On low pressure chillers, moisture typically enters the refrigerant system through ans air leaks from areas with gaskets or fittings The maximum test pressure for leak testing a low pressure centrifugal is: ans 10 psig Leak test and repair the chiller to reduce refrigerant loss from a pruge unit on CFC-11 chiller ans ... A hydrostatic tube test kit is used to: ans determine if a tube leaks Commercial and industrial process refrigeration systems must be repaire...

TFM Fire Extinguisher Rule/Statues and Codes Questions and Answers 100% Pass Fire Extinguishers that are water based shall not be considered a class "C" if the extinguisher has a conductivity higher than? 1.00 μS/cm at 25°C (77°F) Environments containing oxidizers shall be equipped with what type of extinguishing agent? Water A hand portable fire extinguisher shall be installed so that the clearance between the floor and the bottom of the fire extinguisher shall be? 4 in. Fire extinguis...